Ok.. i have a working x mitter !........some questions: plz

[dutchviggen]

Ok, i have a perfectly working x mitter now.

need a antenna: the half wave dipole is ideaal
but what i don´t get.....
should i run the inner cor of the coax to 1 or 2 radials?!?!!

or is it cor to 1 radial; outer to the other radial.

i ´m studying al scheme´s but i doesn´t clear the sky for me.


other question
sound solution. the compressor limiter software for good old winamp,

which options / parts do i switch on. and/or tune which values have you got?!!!!! (screenshot)

thnx indeed


viggen

[Sir Nigel]

I think the outer wire is just an insulator to prevent interference from other rf equipment. As far as sound solution, the presets on it should work fine. Otherwise you could use this really great software MBL4 v6:

https://www.pcs-electronics.com/product ... /software/

[dutchviggen]

Huh?! no, i refer to this image:



if you look very carefully.... you see that there is a difference between the lines running to the arerials.

one is thick....outer connector i suppose.
one is thin.... inner core

than another questions rises.

where does that balun has to be fitted on.
ik know that a BALUN only works if you use the outer connector.

but where do i fit the beginning of the BALUN and where do i fit the end?!

(the end ot the core??)

plz advice

[pcs]

Balun is not required for the RPL0205.