


In fact it only has to do with range/signal coverage.
It might have some effect on actual audio on AM MW band, where
a narrowband antenna makes a difference, if not tuned properly.
Contact me via email, I'll get you in touch with the manufacturer.
Moderators: Sir Nigel, Nina, pcs, 5r, phpBB2 - Administrators
i also read all the post of this user , i think the problem i with the cooling of the amp , you will need to have a good heatsink and 1 or maybe 2 fans blowing fresh cool air over it , or else you will start at 300watts and over time fall to 150 watts or maybe lower , the 3/4 wave antenna is well made and is also well package , i have installed several. i have very little problem with them.Norwalk Electronics wrote:It should be noted that upon further investigation it was found that this customers 300 watt power amplifier was only mounted on the small aluminum heat spreader supplied with the board and not properly mounted on a suitable heat sink. This combined with tampering of R2 (the bias setting) almost certainly caused the amplifier to overheat and operate erratically after a few minutes. It takes basic electronics skills to assemble a working station and burning yourself with RF while adjusting the antenna is not a good sign. An antenna rated at over three times the power of your transmitter would not be in any way responsible for causing distortion or reducing power over time. The High Gain 3/4 wave is guaranteed to outperform every single other antenna on the market for FM transmission.
You will have a smoking pile of electronic garbage, if you do not use heatsink. Moreover, the final mighti also read all the post of this user , i think the problem i with the cooling of the amp , you will need to have a good heatsink and 1 or maybe 2 fans blowing fresh cool air over it , or else you will start at 300watts and over time fall to 150 watts or maybe lower , the 3/4 wave antenna is well made and is also well package , i have installed several. i have very little problem with them.
Norwalk Electronics wrote:It should be noted that upon further investigation it was found that this customers 300 watt power amplifier was only mounted on the small aluminum heat spreader supplied with the board and not properly mounted on a suitable heat sink. This combined with tampering of R2 (the bias setting) almost certainly caused the amplifier to overheat and operate erratically after a few minutes. It takes basic electronics skills to assemble a working station and burning yourself with RF while adjusting the antenna is not a good sign. An antenna rated at over three times the power of your transmitter would not be in any way responsible for causing distortion or reducing power over time. The High Gain 3/4 wave is guaranteed to outperform every single other antenna on the market for FM transmission.