PCS-Electronics

Hello Broadcasters

I think we could show our radio studios:

Here is my studio

With:
1 Behringer Eurorack UB1204 Mixer
1 Mic from ''Shure''
1 Mic (unkown)
1 Computer with SAM Broadcaster as radio automation software
1 Pioneer EQ ( Not at the picture)
1 MAX PRO 3+ transmitter with High-Gain Vertical Half Wave antenna

See the picture here: http://www.fmromerike.110mb.com/studio.htm

Nice setup.

How much range are you getting?

with a car radio i have heard my station over 20km away from the studio, and it was crystall clear, and i have cross a mouintan and I was suprised because the signal was still there:) . Signal was a little bit poor but i can hear the music:)

I would say that is pretty good indeed, for 15W

Marko

Yes,
I wondering to buy a power amp so it come up to above 40W, but i not shure yet.

Did you put a sock over the microphone there?

I hope you washed it first

If you are looking at 40W amplifier module, also check this control board:
https://www.pcs-electronics.com/shop/tv ... oard-v5-0/

With this you can easily set power of your amplifier to any level you need, from 0 to max.

No it's not a sock

It's a ear-pad from an old headset

Hello, long since last time I was here. I thought we could continue this thread, tell about your studio and equipment you use.

I have the same as listed in the first post, but i have upgraded to a 150W amp.
And use Limbo 1 Compressor and SE5000 DSP stereo encoder with RDS.

I have upload a sound example so you can hear, and tell us about your equipment

Example: http://www.dump.no/files/6194dd459c42/example.MP3