PCS-Electronics

Here is what i can not understand . I have a pcimax 2006+ w/rds and a 15w booster . the card is connected with the booster with the included cable (which has 2 male satellite plugs ). Now the setup works fine (i have very good sound very low sw in the output of the booster ) but the led in the backpanel of the pcimax card lights always!! This led i think it shows the sw level in the output of the pcimax card right?. So why the led shows that i have sw in the output when is connected to the booster ? Is this ok ?

I think the light just indicates the card is on. It's always lit on mine.

Hello,
The light on the back is just to let you know the unit is on, there are 2 leds on the card itself if you open up you computer that light up do to over modulation and I think audio peaks you want those lights not to come on no more than they have too I have mine set to were they just do flicker when my meters on my SAM3 software reach 0db.

hope this helps