PCS-Electronics

How did you run it? You're supposed to unpack the zip file
and than run the setup. If you run the setup.exe from inside
winzip or winrar it only extracts the exe and the other files
are not found.

Hi

I unzipped it as you said. The three files were extracted.
Then I did run the exe file.

Whoa, on my test system it went smoothly. Some other people reported success
as well, not sure what the issues are with this one.

Hi again
the external power dind't help still no signal... any chance there's somthing wrong with my card?
what's the next step here? do I send it back ?

best regards
Thomas

Hi Thomas,

it may be a hw error than, can you drop me an email directly
with a photo of the card?

Hi again

Sometimes the card just don't switch on if I press the power-button.
Is that normal?
It takes several trys before the card starts broadcasting.
What could that be?

There is usually delay before a click and power on. When you click wait a few seconds
for the PLL to acquire lock and stabilize.

If you check at the back the power on LED turns on immediately.

Hi

Well, sometimes it does not start to broadcast.
Even if I wait. I need to play with the power-switch to get it
to broadcast. If it starts it is all ok and plays fine, but it takes
several trys and if i change the output-power sometimes it just
stops broadcasting.
Weird.

Looks like the PLL is slow to lock onto frequency.

At least it is not a show-stopper, just a bit annoying.

Well, I can live with that.
As long as it starts.
Really a great product.