New product/manual: SE5000 DSP+

Post by **pcs** » Sat May 03, 2008 7:15 pm

https://www.pcs-electronics.com/shop/st ... o-encoder/

Here is the manual:
http://www.pcs-electronics.com/software ... dsp_en.pdf

The major improvement in this unit is the new I2C connector. Now you do not have to solder at all
to connect I2C bus together, check the manual.

There are also some other small improvements, all in all a nice unit to have and operate.

We have more than 100 units on stock so they are shipping immediately.

octanerocks · Post by **octanerocks** » Fri Mar 13, 2009 8:47 am

The manual contradicts itself. It says the J10 jumper has to be installed for I2C/LCD operation, then later it says it has to be installed for stand-alone operation

lol

I figured it out though...

Post by **pcs** » Fri Mar 13, 2009 10:00 am

Fortunately I also wrote it down on the board so it is really easy to figure out without the manual.

Thanks for the comment, I'll update the manual.

Uploaded already...

Post by **pcs** » Fri Oct 22, 2010 1:36 am

Updated manual, the MAXLINK cable in scenario C does not connect to LCD module anymore.

It now connects to RF board of MAX PRO 3000+ or MAX PRO 4025+.

Post by **pcs** » Thu Jul 25, 2013 10:44 am

Manual update.

Post by **pcs** » Tue May 12, 2015 1:54 pm

Manual small update